This is the Futaba R149DP 9-Ch 72MHz PCM 1024 Dual Conversion Receiver. This receiver works with both High and Low band crystals and replaces the older R149DP receivers on separate High and Low bands.
FEATURES: Narrow-band spacing and dual conversion signal filtering combine to provide exceptionally clear, interference-free reception and amazingly smooth, accurate control One year limited warranty
INCLUDES: One R149DP 9 Channel 72MHz PCM 1024 Receiver
REQUIRES: One Dual Conversion Receiver Crystal depending on channel required; Low Band, (ch 11-35) FUTL57** High Band, (ch 36-60) FUTL58** High Band, (ch 61-90) FUTL59**
SPECS: Narrow Band: 20KHz Intermediate Frequency- 1st IF: 10.7MHz 2nd IF: 455kHz Power Requirements: 4.8 to 6.0V (shared with servos) Current Drain: 15mA Length: 2.16" (55.0mm) Width: 1.28" (32.6mm) Height: 0.82" (20.8mm) Weight: 1.2 oz (34.5g)
COMMENTS: To Identify as newer R149DP from the older ones, remove the crystal and look at the PCB board that is standing up. If there are no traces and solder (just an empty board) it is the new one. 1024 Resolution is NOT Compatible with Older PCM 512 Systems. For the transmitter/receiver crystal set, use FUTL20**. Special Notice about Frequency Changes- *72MHz- You may change channels within this band. *50MHz, 27MHz and 75MHz receiver crystals Can be changed anywhere within the respective bands. There are no High or Low bands such as the 72MHz band has. *Transmitter Crystals cannot be changed to another channel except by a licensed service center. It is against FCC regulations, and illegal for the user to change a frequency determining component of a transmitter. If the radio is not retuned, it can be a hazard spectators, modelers or property, and void AMA insurance coverage. *Check with the local R/C club for the frequencies used in your area.
